Panel standards

Units: mm
Location Fire-resistant performance
(time)
Thickness Width Length
(maximum span)
Remarks
  Panel type
Outer wall Flat panel 1 100 300`600 600`4,100i3,500j  
1 125 300`600 600`4,920i4,200j
1 150 300`600 600`6,000i5,250j
Design
(soft type)
1 100 600 600`3,750i3,200j Groove depth
Soft 9mm
(100mm thick is
8.5mm)
1 125 600 600`4,100i3,500j
1 150 600 600`4,500i4,200j
Design
(hard, mixed,
dynamic types)
1 125 600 600`4,100i3,500j Groove depth
Hard 15mm
Dynamic 25mm
1 150 600 600`4,500i4,200j
Design
(A line)
1 100`150 600 600`4,100i3,500j  
1 125`175 600 600`4,920i4,200j
GfasTM 1 100 300`600 600`3,690i3,150j Groove depth
100mm thick 10mm
125mm thick 15mm
1 125 300`600 600`4,100i3,500j
CanvasTM 1 100 600 600`3,750i3,200j Groove depth
8.5mm
1 125 600 600`4,100i3,500j
1 150 600 600`4,200i4,200j
Partition wall 1 75 300`600 600`4,000  
1 100 300`600 600`5,000
1 125 300`600 600`6,000
1 150 300`600 600`6,000
Roof 0.5 75 300`600 600`2,220i2,000j
0.5 100 300`600 600`3,300i3,000j
0.5 125 300`600 600`3,870i3,500j
0.5 150 300`600 600`4,650i4,200j
Floor 1 100 300`600 600`2,400
1 125 300`600 600`2,700
1 150 300`600 600`3,100
2 125 300`600 600`2,500
2 150 300`600 600`3,000

Note 1: Manufacturered at 10mm pitch within above range for panel width and length.
Note 2: Panel length is restricted by the yield of the installation for each combination of wind pressure and installing method for exterior walls, by the total of load and finishing load for floors, and by the total of load, finishing load, and negative wind pressure for roofs.
Note 3: Maximum length is 5,120mm when when installing 125mm thick 125mm thick partition wall panels with the L plate method.
Note 4: The eaves of a roof in the length direction should be no more than three times as much as the panel thickness, or no more than 200mm when the finishing load is 2400N/m2 or greater.

Corner panel standards

Return to top of page